U Bend Tube For Heat Exchanger

Product Details

U-Bend Tube

U-bend tubes are widely used in heat-exchanger systems. Heat-exchanger equipment on the basis of seamless stainless U-tubes is essential in strategically important and critical fields — nuclear and petrochemical machine building.

A tube-bending line, that was installed at our factory in the end of 2005, allows to produce U-tubes 

as per such standards:

1. ASTM A688/A688M

2. ASTM A803/A803M

3. ASTM A556/A556M, ASME SA-556

4. ASME SA-179/SA213

Tubes of other alloys and steel grades can be produced upon agreement.
Technical requirements
Straight tubes for bending:
ASTM/ASME SA 179; SA 213; ASTM B 163; ASTM B 729; ASTM B 407; ASTM B 423; ASTM A 789
U-bend Tubes:
-TEMA RCB 2.31 Standards of the Tubular Exchanger Manufacturers Association (9th edition).
-ASTM A688 Standard specification for welded tubes of austenite corrosion resistant steel grade designed for feed water boilers.
-ASTM B163 Standard technical requirements for tubes of nickel and nickel alloy for condensers and heat exchangers.
-Customer specifications.

u bending

BENDING RADIUS: from 1.5 OD to 1250 mm.
When ordering tubes with R≤1.5D it is necessary to agree precision of geometrics.
STRAIGHT TUBES MAXIMUM LENGTH (before bending): 26000 mm.
LEG LENGTH: min 1 meter, max 10.5 meters (for max R=1250 mm)
Note: other sizes are available upon agreement.
HEAT TREATMENT: Stress Relieved after U bending.
HYDROSTATIC TEST: maximum test pressure 600 bar, soaking 10 sec. with demineralized water. Compressed air cleaning after hydro-test.
Marking: before bending by marking machine all over the tube length (bent section after heat treatment without marking).
Marking is also possible after bending on the straight parts of U-bent tube.
Packaging: closed wooden boxes of corresponding dimensions for each tube length, radius, diameter, according to PO requirements or in bundles wrapped in polyethylene film with plastic clamping spacers on each tube.